Gutter rehanging
Sagging gutters are rehung on solid fascia with new hangers so they drain instead of overflowing.
Exterior Services
Fascia Repair Rutherford, NJ
A roofer in Rutherford can repair or replace rotted fascia boards, reattach sagging gutters and fix the drip edge that keeps water off the wood, so the gutters have solid wood to hang from again. Dial (551) 380-1579 to talk with a local roofer about the fascia.
Fascia rot nearly always comes from water getting behind the gutter. Without a drip edge lapped into the gutter, runoff clings to the roof edge and wets the top of the fascia every storm. Over a few seasons the wood softens, the gutter screws lose their grip and the gutter starts to sag or pull away.
What starts as a soft board can spread well past the trim. Behind the board are the rafter tails, the roof decking at the edge and the soffit, and water that gets past the fascia soaks into all of them. On homes with metal fascia wrap, the rot often goes unseen until the gutter falls.
Before the visit, take a look along the roof edge from the ground. Note where paint is peeling, where gutters sag or have pulled away, and whether water pours over the gutter in heavy rain. Mention whether the fascia is painted wood, PVC or covered in aluminum, and how old the gutters are.
If the problem goes deeper than it first looked, a Rutherford roofer may also recommend soffit repair or gutter installation.
Dealing with this in Rutherford, NJ right now? Call (551) 380-1579 to reach a nearby roofing contractor.
Call nowThe process
How fascia repair works
Good fascia work deals with the roof edge, the gutter and the board together.
Find the water path
Before the board comes off, the roofer looks at what has been soaking it, from the shingle edge to the downspout. The length of the damage decides how much board is replaced.
Free the board
The gutter section over the damage is unhooked and set aside so the fascia can come off. Old spikes and loose hangers are not reused.
Check the rafter tails
The roofer looks at the rafter ends and the sub-fascia, since soft framing will not hold a new board. This is the step that decides whether the repair lasts.
Replace the boards
A replacement board matched to the existing size goes up, sealed at the ends and joints. Wood is primed on every side, including cut ends, before it goes up.
Close the gap
Drip edge flashing is slid under the shingles and over the gutter back, so water cannot reach the wood. It is a small part that does most of the work.
Reattach gutters
The gutter goes back up with new hidden hangers screwed into solid wood, pitched toward the downspout. Wood fascia gets a finish coat of paint.
What is included
What fascia repair covers
Aluminum wrap
Metal wrap can be added over new or sound fascia with the drip edge lapped over it.
Rotted board repair
Soft wood along the roof edge is removed back to sound material so gutters have solid backing.
Framing repair
Rotted rafter ends behind the fascia are sistered or rebuilt so the new board stays put.
Edge flashing
Missing or bent drip edge is replaced at the roof edge so water drops into the gutter.
Related service
Fascia Board Replacement Rutherford, NJ
Fascia board replacement means taking off whole lengths of board rather than patching short sections. The gutters come down, the old boards come off and the rafter tails behind them are checked before new boards go up. It is also the moment to choose a material, whether primed wood, PVC, composite or wood with an aluminum wrap.
In Rutherford, fascia board replacement often lines up with a new roof or new gutters, since the roof edge is already being worked on. Make sure rotted boards are removed, not covered. The new boards should match the old width so the soffit closes properly.
Related service
Fascia Board Repair Rutherford, NJ
When rot is confined to short stretches, the damaged part of the board can be cut out and a new piece scarfed in. A scarf joint, cut at an angle and glued and fastened, blends the new piece into the old board and sheds water better than a square butt joint. Very small areas of surface rot can sometimes be treated with a wood consolidant and exterior filler, then primed and painted.
The repair is only worth doing if the water source is fixed at the same time. Common fixes include a resealed gutter joint, a cleared outlet or a new length of drip edge. Sealed and painted, the patch holds up like the original wood.
Local help
Fascia Repair Near Me
In Rutherford, fascia tends to fail first on the sides of the house where gutters clog fastest. From Rutherford out to neighboring towns such as East Rutherford, Wallington, Carlstadt and North Arlington, older roof edges often need board and rafter tail repair while newer ones more often need drip edge and gutter fixes, and replacing a short section early is far easier than rebuilding the roof edge later.
Need fascia repair around Rutherford? Call (551) 380-1579 for a Rutherford roofer who serves the towns around it too.
Roofs in this climate
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Rutherford is busiest after a hard winter and before the next one.
Why call
Why fix it now
Drier ceilings
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Familiar with local homes
Local roofers see the same roofs and storm damage across Rutherford and nearby towns.
Know what happens next
Ask your questions before you agree to anything.
Common questions about fascia repair
Why do gutters pull away from the fascia?
A gutter is only as secure as the board behind it. When the wood softens, hanger screws and spikes lose grip and the gutter sags, tips forward or pulls away. The fix is solid wood plus new hangers, pitched toward the downspout.
Which fascia material lasts longest?
Rot-proof materials such as PVC and composite last longest. Wood is common on older homes and works well when kept painted. The drip edge and gutters decide how long any fascia lasts.
Is it safe to wrap rotted fascia in aluminum?
Wrapping over soft fascia traps moisture and lets the rot continue unseen. Since gutters hang from the wood, the problem shows up later as a falling gutter. Fix the wood, then add wrap over it.
What causes fascia boards to rot?
Fascia rots when water runs down the board instead of into the gutter. Clogs, bad seams and the lack of a drip edge are the usual culprits. Peeling paint and unsealed cut ends speed up the damage.
Can fascia be repaired instead of replaced?
Short sections of rot can be repaired by cutting out the bad wood and scarfing in a new piece. If the damage is widespread, new boards end up being the simpler fix. The roofer will probe the wood to see which option fits.
More questions? Call (551) 380-1579
Often needed together
Soffit Repair
Repairs for rotted, sagging or loose soffit panels under the roof eaves, before rot spreads into the fascia and rafter tails.
Learn moreGutter Installation
Seamless gutter installation sized to the roof, pitched to the downspouts and hung on hidden hangers, so water ends up where it should.
Learn moreGutter Repair
Gutter repair for leaking seams, sagging runs, loose hangers and broken downspouts, so roof water drains where it should again.
Learn moreRoof Repair
Repairs for missing shingles, lifted tabs, cracked pipe boots, loose flashing and soft decking, without replacing a roof that still has life left.
Learn more
Looking for something else?
See all roofing servicesGet fascia repair help in Rutherford
Call (551) 380-1579 to talk to a roofer serving Rutherford, NJ.