Deck repair
The base under the roof is made sound for a straight, solid roof.
Metal Roofing
Metal Roof Replacement Rutherford, NJ
A Rutherford roofer can tear off an old metal roof, re-cover it with new metal or replace a shingle roof with metal, and help you decide between a tear-off, a re-cover or new panels in just the bad sections. Call (551) 380-1579 to reach a local roofer.
Replacement comes up once rust or wear has spread past what patches and new fasteners can fix. Rust that has eaten through panels in many places, paint that has chalked and worn down to bare metal and screw holes that have wallowed out across the whole roof all point toward new panels. Older roofs made from thin, lightly coated steel tend to reach that point first.
Not every metal roof replacement starts with a tear-off. Tearing off lets the roofer see rotten purlins, soft decking and rusted fasteners before anything new is installed. In a retrofit, new panels go over the old roof on a framing system, avoiding tear-off on large or occupied buildings.
Plenty of homeowners replace an old shingle roof with metal rather than more shingles. The shingles can come off or, if local code permits and the deck is sound, the metal can go over them. Before calling, note the roof age, the type of panels or shingles on it and where it leaks.
Metal Roof Replacement is often paired with metal roof installation and metal roof repair, depending on the cause.
Dealing with this in Rutherford, NJ right now? Call (551) 380-1579 and describe the problem to a roofer who works in Rutherford.
Call nowThe process
The metal roof replacement process
The order of work depends on tear-off or re-cover, but the basics are the same.
Inspect the structure
The roofer counts rust-through spots, checks the finish and inspects the purlins or decking from inside the attic or building. It also tells whether the framing needs work first.
Pick the system
The roofer and owner pick the panel profile, metal and color and decide how the old roof will be handled. Moving from purlins to standing seam often calls for a full deck.
Tear off
Old panels, trim and fasteners are removed and sorted for scrap metal recycling. The roof is never left open overnight.
Fix the purlins
Rotten purlins are replaced, loose ones refastened and soft decking cut out and renewed. This step is skipped on a re-cover, which is why the structure is checked first.
Put on the new roof
New underlayment, eave trim, panels, ridge cap and flashing complete the replacement. Gutters may be reset to match the new eave line.
What is included
A complete metal replacement
Retrofit framing
A retrofit re-cover avoids a tear-off with fasteners driven into the structure below.
Flashing
New trim and boots at walls and penetrations so the details last as long as the panels.
Metal panels
The new metal system is fastened to the manufacturer pattern.
Old roof removal
The worn roof is stripped down to the framing so the structure can be inspected.
Related service
Metal Roof Panel Replacement Rutherford, NJ
Metal roof panel replacement swaps out individual damaged panels instead of the whole roof. On exposed fastener roofs, the roofer removes the screws on the damaged panel and the overlapping edges of its neighbors, slides it out and sets a new one in sealant. Standing seam panels can be replaced too, but it takes more work to unseam and reseam the neighbors.
On a Rutherford roof that is otherwise sound, a few new panels can add years of service. The new panels may look brighter until they weather. Once a large share of panels need work, replacement becomes the better plan.
Related service
Metal Roof Over Shingles Rutherford, NJ
A metal roof over shingles skips the tear-off and installs panels over the current shingle layer. Many codes allow it over a single layer of shingles, and the metal usually goes on over new underlayment, a slip sheet or wood battens.
The tradeoff is that nobody sees the deck. A roofer in Rutherford should check the attic for rot and soft spots before recommending it, and the shingles must lie flat enough for the panels. If the deck is questionable or there are already two layers, a tear-off is the better choice.
Local help
Metal Roof Replacement Near Me
In Rutherford, many metal replacements are older galvanized roofs that have finally rusted through. From Rutherford out to neighboring towns such as East Rutherford, Wallington, Carlstadt and North Arlington, older metal roofs tend to need full replacement once the coating is gone, and newer houses are adding metal as their shingle roofs wear out, which is why the condition of the purlins and deck drives the plan.
Need metal roof replacement around Rutherford? Call (551) 380-1579 for a Rutherford roofer who serves the towns around it too.
Roofs in this climate
Cold winters bring snow, ice and a long stretch of freezing nights. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. Most homeowners in Rutherford, NJ have the roof checked in the fall and again after the snow melts.
Why call
Why act early
Smaller repairs
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Familiar with local homes
Local roofers see the same roofs and storm damage across Rutherford and nearby towns.
Clear next steps
Ask your questions before you agree to anything.
Metal Roof Replacement FAQ
Is old metal roofing recycled?
Removed metal panels are generally recycled. Metal can be melted down and reused, so it rarely goes to the landfill. Your roofer can explain how the old metal will be hauled away.
When does a metal roof need replacing instead of repair?
The tipping point comes when rust or wear is spread across the roof, not just in a few spots. If panels are perforated, the coating is gone and the fasteners no longer hold, patches will not keep up. Call (551) 380-1579 to have a roofer check the roof and the structure.
Can a new metal roof go over the old metal roof?
A metal re-cover puts a new metal roof on top of the old one, attached through new framing to the structure. It avoids tear-off and keeps the building closed during work, which is why it is common on shops, barns and commercial buildings. An engineer or roofer confirms the framing can carry the added load.
Can a metal roof be installed over shingles?
Where code permits, metal can go over a single layer of shingles. It works best when the deck is sound and the shingles lie flat. If the deck is questionable or there are two layers already, a tear-off is the better route.
How is a single metal roof panel replaced?
Replacing one panel is a routine job on most ribbed and corrugated roofs. The screws and laps are freed, the bad panel slides out and a new panel of the same profile is lapped in with sealant and new fasteners. New panels may look brighter than the old ones at first.
More questions? Call (551) 380-1579
Other services that may help
Metal Roof Installation
New metal roofs in standing seam, exposed fastener, metal shingle and stone coated steel, with high-temperature underlayment and proper flashing.
Learn moreMetal Roof Repair
Replacing worn screws and washers, resealing panel laps, treating rust and fixing loose trim on metal roofs, so the panels keep shedding water for years more.
Learn moreRoof Replacement
A complete new roof from the deck up when repairs no longer make sense, built to current code from the decking out.
Learn moreStanding Seam Metal Roof
Long-lasting standing seam roofs, from snap-lock to mechanically seamed panels, with matching trim, closures and snow guards.
Learn more
Looking for something else?
See all roofing servicesNeed metal roof replacement in Rutherford, NJ?
Call (551) 380-1579 for a local roofer in Rutherford and nearby towns.