Curb flashing repair
Loose base flashing is reattached under a termination bar to stop leaks at the details.
Flat Roofing
TPO Roof Repair Rutherford, NJ
TPO roof repair in Rutherford usually comes down to finding an open seam, a puncture or a loose flashing and welding new membrane over it, as long as the membrane is still flexible enough to take a weld. Dial (551) 380-1579 to talk with a local roofer about the leak.
Most TPO leaks come from a handful of spots, and each has a standard fix. Seams that were welded too cold or have been stressed by movement can open along a lap, and a seam probe finds them fast. Punctures from dropped tools, hail or foot traffic around equipment are the other big source, along with flashings that pull away at curbs, walls and pipes.
Patching TPO is not a caulk job. An aged sheet must be cleaned with a weathered membrane cleaner so the hot-air welder can fuse the patch to it. When a sheet is too far gone to weld, sealant patches are only a stopgap.
The drip inside is rarely right below the hole. Water can travel across the top of the insulation or along the flutes of a steel deck before it finds a gap to drip through. Note where and when it drips, whether in every rain or only in wind-driven storms, and whether anyone has worked on the roof lately. If the drip is near electrical fixtures, turn off that circuit at the panel when it is safe to reach.
Depending on what the roofer finds, tpo roof repair in Rutherford, NJ can go hand in hand with tpo roofing and flat roof repair.
Need tpo roof repair in Rutherford? Call (551) 380-1579 to reach a nearby roofing contractor.
Call nowThe process
What happens during a TPO repair
Here is how a roofer typically handles a TPO leak.
Search the roof
The roofer starts inside to see where water is showing, then walks the roof above and upslope of it. A probe along the seams finds cold welds, and a controlled water test can confirm a suspected spot.
Cut a core
A core sample near the leak tells the roofer how far the water has spread through the insulation. Soaked insulation is removed and replaced before the membrane is closed back up.
Prep the membrane
Old TPO is cleaned and dried so the new membrane will fuse to it. A test weld on the old sheet confirms it will still take heat.
Weld the repair
Patches are cut from new membrane, corners rounded so they do not peel, and welded on all sides. Where seams cross in a T-joint, a round patch covers the step in the lap.
Reflash penetrations
Failed pipe boots are replaced with new molded boots, curbs are reflashed and loose wall flashing is reattached with a termination bar. Drain clamping rings are tightened or replaced so water cannot slip under the membrane at the drain.
Probe the finished work
Finished welds are probed to make sure there are no gaps. Ask for a written note of each repair location so future work is easier.
What is included
What TPO repair covers
Penetration repair
Pipes and conduit get new boots or field-wrapped flashing and clamped tight.
Puncture patches
Holes and cuts are covered with welded TPO patches after the area is cleaned.
Wet insulation replacement
Soaked insulation under a leak is cut out and new boards set before patching.
Seam rewelding
Lifted laps are cleaned and fused again and probed after cooling.
Related service
TPO Roof Maintenance Rutherford, NJ
A TPO roof needs less upkeep than older flat roofs, but it is not a no-maintenance roof. Twice a year, and after big storms, a roofer should walk the roof to look at seams, curbs, pipe boots, edge metal and drains. Picking up debris and anything sharp is a small step that prevents a lot of punctures.
Walkway pads to and around rooftop units protect the membrane where people walk most. Washing the membrane every few years with a mild cleaner and a soft brush keeps it reflective and makes later repairs weld better. In Rutherford, a short written log of each inspection and repair, with dates and locations, makes the roof much easier to manage over the years.
Local help
TPO Roof Repair Near Me
TPO roof repair calls in Rutherford come from homes with low-slope sections and from stores, offices and warehouses alike. Buildings in Rutherford and around East Rutherford, Wallington, Carlstadt and North Arlington carry a lot of equipment on their roofs, and the membrane around that equipment takes the most wear, which is why the leak search matters as much as the patch.
For tpo roof repair in Rutherford, NJ or nearby towns like East Rutherford, Wallington, Carlstadt and North Arlington, call (551) 380-1579 to reach a roofer who covers your street.
Roofs in this climate
Cold winters bring snow, ice and a long stretch of freezing nights. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Rutherford is busiest after a hard winter and before the next one.
Why call
Why fix it now
Drier ceilings
Small roof problems caught early usually stay small repairs.
Roofers who know Rutherford
Roofers in Rutherford know the roof types and weather wear common in local homes.
Clear next steps
Ask the roofer about the cause, the options and the estimate before work starts.
TPO Roof Repair FAQ
Can I go up on my TPO roof to look for the leak?
TPO can take careful foot traffic, but the roof itself can be a dangerous place. Never climb onto a wet, icy or storm-damaged roof, since wet TPO is slick and flat roofs often lack edge protection. Let the roofer handle the search with proper fall protection.
When does a TPO roof need replacing instead of repair?
Repair makes sense when leaks are few, the membrane is still flexible and the insulation is mostly dry. If the membrane cracks when folded, will not take a weld or covers a lot of wet insulation, replacement or a recover is likely. A moisture survey and a test weld settle most cases.
Can a TPO roof be patched?
A puncture or open seam in TPO is fixed by welding a patch of new membrane over it. After cleaning the surface, the roofer welds the patch on all sides and checks it with a probe. Sealant or tape can serve as a temporary fix, but a weld is the lasting repair.
Will a TPO patch hold up?
A good welded repair fuses into the sheet, so its life matches the surrounding membrane. Sealant patches and welds on poorly prepped sheets do not last nearly as long. A leak that returns after a patch means the real source is somewhere else.
Why does my TPO roof leak at the seams?
A seam leak typically starts with a weld that was too cold, too fast or done on a dirty sheet. Weak welds can pass at first and then let go after seasons of heat and cold. Look first at T-joints and at seams near curbs and walls.
More questions? Call (551) 380-1579
Related services
TPO Roofing
Heat-welded TPO membrane for flat and low-slope roofs, with seams welded into one watertight sheet.
Learn moreFlat Roof Repair
Flat roof repairs matched to the membrane, whether EPDM, TPO, PVC, modified bitumen or built-up, with the patch made from material that bonds to what is there.
Learn moreCommercial Roof Repair
Repairs for leaks, open seams, failed flashings and clogged drains on commercial roofs, done around business hours.
Learn moreRoof Coating
Silicone, acrylic and other liquid coatings that renew aging flat, low-slope and metal roofs, after the seams and blisters are repaired.
Learn more
Looking for something else?
See all roofing servicesGet tpo roof repair help in Rutherford
Call now for Rutherford tpo roof repair and help in the towns around it.